NETWORK DESIGN Of INDOOR 4G LTE 1800 MHZ IN BALIKPAPAN STATE POLYTECHNIC ELECTRONIC BUILDING USING RADIOWAVE PROPAGATION SIMULATOR 5.4
Indoor area is an area that lacks a signal so that the signal attenuation continues to be problems that often occur. To overcome these problems need the support of a communication system that can include a signal in the room so that customers can keep communicate with smoothly. The need for application of indoor mobile communications system to support the outdoor system that can serve the entire mobile service users. This research discusses the planning of indoor femtocell LTE 4G network at the electronics building of the Balikpapan State Polytechnic is on the floor 1,2 and 3 with models Cost 231 multiwall indoor propagation. This design is simulated using 5.4 Software Radiowave Propagation Simulator (RPS). From the calculation results, the number of Femtocell Access Points (FAP) on each floor is 3, the placement of FAP in the middle part of each floor of the Electronics building. From the design results obtained on the 1st floor RSRP value of -32.18 dBm and SIR of 12.31 dB, for floors 2 RSRP -34.20 dBm and SIR of 13.52 dB, and floor 3 RSRP value of -33.32 dBm and SIR is 13.27 dB
Ulfah. Maria, (2016), “Analisis Jumlah e Node B LTE untuk kota Balikpapan”, Jurnal Sains Terapan. Politeknik Negeri Balikpapan Vol 2 No.1 halaman 56-59.
Wardhana.Lingga, dkk, (2014), 4G Handbook Edisi Bahasa Indonesia, www.nulisbuku.com, Jakarta
Hikmaturokhman.Alfin,dkk,(2015), ”Analisa Model Propagasi COST 231 Multi Wall Pada Perancangan Jaringan Indoor Femtocell HSDPA Menggunakan Radiowave Propagartion Simulator”,STTT Telkom Purwokerto
Copyright in each article is the property of the author.
- The author acknowledges that the Jurnal Ecotipe (Electronic, Control, Telecommunication, Information, and Power Engineering) has the right to publish for the first time with a Creative Commons Attribution 4.0 International License.
- The author can enter the writing separately, regulate the non-exculsive distribution of manuscripts that have been published in this journal into other versions (for example: sent to the author's institution respository, publication into books, etc.), by acknowledging that the manuscript was first published in the Jurnal Ecotipe (Electronic, Control, Telecommunication, Information, and Power Engineering);