VARIASI SUDUT POTONG DAN KECEPATAN POTONG TERHADAP LAJU PEMAKANAN MATERIAL SCM 440
Abstract
During the workpiece turning process, several factors affect the final workpiece, such as the cutting angle and cutting speed. The purpose of this study was to determine the effect of variations in cutting angle and cutting speed on the material consumption rate of SCM 440. The method used in this study is the Response Surface Methodology (RSM), with a two-parameter design, each of which has three levels for each parameter variation. . The results of data analysis obtained eigen values with different signs (positive and negative) which indicated that the stationary point values were in the form of saddle points with a stationary point values of x1 (cutting angle) of -1.686 and x2 (Vc) of 0.199. From the uncoded process, the optimal value for the MRR factor is obtained, namely the cut angle of 10.64° and Vc of 15.28 m/min. The optimum feed rate for SCM 440 material is obtained at an optimal value of neither minimum nor maximum or a saddle point shape at a cutting angle cut of 10.64° and Vc of 15.28 m/min with an MRR area of 300-400 mm3/minute.
Downloads
Copyright (c) 2023 Arianda Pratama
This work is licensed under a Creative Commons Attribution 4.0 International License.
The paper presented is assumed not to contain proprietary materials that are not protected by patents or patent applications. Responsibility for technical content and for protection from proprietary materials is the responsibility of the author and their organization and not the responsibility of the machine or its editorial staff. The primary author (first / appropriate) is responsible for ensuring that the article has been viewed and approved by all other authors. It is the responsibility of the author to obtain all copyright release permits required for the use of any copyrighted material in the manuscript before submission.