RANCANG BANGUN MESIN PEMOTONG PIPA DENGAN LAS OXY ACETYLENE
Abstract
Metal cutting is the stage of processing profile raw materials and steel plates according to the cut marks that have been set in the marking process. One of the metal cutting techniques is to use oxy acetylene welding where the cutting occurs due to the reaction of oxygen and steel. Oxy acetylene welding is a manual cutting and welding process, in which the surfaces to be joined are heated until melted by the flame of acetylene gas, namely burning C₂H₂ with O₂ with filler metal or without filler metal where the joining process is without pressure. Besides for welding purposes (connection), oxy acetylene welding can also be used as preheating, brazing, cutting and hard facing. In the process of cutting iron pipes using oxy acetylene welding manually, the problem that is often found is the results of uneven and not straight cuts. This causes a leveling process to be needed on the edges that are cut so that they are flat and straight. In this research, a pipe cutting machine with oxy acetylene welding has been made which aims to produce straight, smooth, and even pipe cutting. The pipe cutting machine that has been made can produce flat, smooth, and straight iron pipe cuts on iron pipes with a diameter of 4.5 inches, 3.5 inches and 3 inches with a cutting time of 32 seconds, a motor wave rotation speed of 5.8 Hz, and a cut tolerance of ± 3 mm.
Downloads
Copyright (c) 2023 Jeri Ariksa, Yudi Setiawan, Kadriadi Kadriadi, Amiruddin Amiruddin, Angga Bahri Pratama
This work is licensed under a Creative Commons Attribution 4.0 International License.
The paper presented is assumed not to contain proprietary materials that are not protected by patents or patent applications. Responsibility for technical content and for protection from proprietary materials is the responsibility of the author and their organization and not the responsibility of the machine or its editorial staff. The primary author (first / appropriate) is responsible for ensuring that the article has been viewed and approved by all other authors. It is the responsibility of the author to obtain all copyright release permits required for the use of any copyrighted material in the manuscript before submission.