MODIFIKASI DIAMETER INLET DAN PENGARUH KEKERASAN KARET TERHADAP HASIL LADA PADA MESIN PENGUPAS LADA SISTEM CRUSHER
Abstract
Based on previous research, specifications of machine have a slope of a dish of 0.68 ° and inlet diameter of 30 mm, produce 1 kg/hour of input capacity and 0.64 kg/hour of output capacity. From the evaluation results, to increase the input capacity it is necessary to increase the inlet diameter and analyze the effect of rubber hardness on the results of peeling pepper. Modifiying the inlet diameter, input capacity increase to 6 kg/hour or increasing 5 times compared to the input capacity of the previous research. For hardness of rubber 60 shore A, the percentage of pepper peeled was 72.13% with an engine output capacity of 4.33 kg/hour. For rubber hardness of 70 shore A, the percentage of pepper peeled was 73.03% with an engine output capacity of 4.38 kg / hour. Visually, dry pepper with a hardness of 60 shore A whiter than dry pepper hard with a hardness of 70 shore A.
Downloads
References
Delvitasari, F. (2018). KARAKTERISTIK SIFAT FISIKA KOMPON KARET ALAM SEBAGAI BAHAN DASAR FOOTSTEP SEPEDA MOTOR DENGAN BERBAGAI FORMULA. Jurnal Dinamika Penelitian Industri, 29(1), 29–34.
Rosa, F., Rodiawan, & Saparin. (2018a). ANALISA HASIL UJI COBA MESIN PENGUPAS BIJI LADA MENGGUNAKAN SISTEM CRUSHER DENGAN VARIASI KEMIRINGAN PIRINGAN SEBESAR 0,53° INFORMASI ARTIKEL ABSTRAK. Fly Wheel, IV(1), 1–4. Retrieved from http://jurnal.untirta.ac.id/index.php/jwl
Rosa, F., Rodiawan, & Saparin. (2018b). RANCANG BANGUN PENGUPAS BIJI LADA MENGGUNAKAN SISTEM CRUSHER. Jurnal Ipteks Terapan, 12(2), 177–183. https://doi.org/10.22216/jit.2018.v12i2.3127
Zuhra, C. F. (2006). Cut Fatimah Zuhra, SSi. MSi. USU Repository, 1–30.
Copyright (c) 2018 Firlya Rosa, Rodiawan Rodiawan, elyas kustiawan

This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
The paper presented is assumed not to contain proprietary materials that are not protected by patents or patent applications. Responsibility for technical content and for protection from proprietary materials is the responsibility of the author and their organization and not the responsibility of the machine or its editorial staff. The primary author (first / appropriate) is responsible for ensuring that the article has been viewed and approved by all other authors. It is the responsibility of the author to obtain all copyright release permits required for the use of any copyrighted material in the manuscript before submission.