PREDIKSI TITIK LAS BAJA TULANG KING CROSS MENGGUNAKAN METODE TAGUCHI DI PT. XYZ
DOI:
https://doi.org/10.33019/jm.v11i1.4643Keywords:
las titik, kingcross, metode taguchiAbstract
Welding is a process of combining materials that produces melting at welding temperature, either by applying pressure or without pressure, and using filler metal or without using it. Before the welding process is carried out, it is necessary to place spot welds which aim to hold the previous position during the welding operation. The spot welding process is carried out by placing small lumps of weld on the welding line. Therefore, this research needs to be carried out to determine the effect of the number of spot welds and predict the weld points on king cross bone steel using the Taguchi method. The Taguchi method is used to arrange an orthogonal array for the layout of the experiment. In this method, the experimental results must first be analyzed for accuracy to meet certain conditions. Based on the results of research using the Taguchi method in predicting weld points, it was found that the main factor that most influences the build up setting of Kingcross is the distance between weld points, the second factor is the number of weld points, and the third factor is the length of the weld points.
Downloads
References
[2] Jeffus L., Welding: Principles and Applications, Eighth ed. Boston: Cengage Learning, 2017.
[3] Marlow F.M., Welding fabrication & repair: questions and answers. New York: Industrial Press Inc., 2002.
[4] Oentoeng, Konstruksi Baja, vol. 06, no. 01. 2013.
[5] Purboningtyas A.S., Suswanto Budi, dan Kristijanto Heppy. Modifikasi Perencanaan Struktur Gedung Hotel Santika Bekasi Menggunakan King Cross Column dan Octogonal Castellated Beam.Repository ITS, 2016, pp.1-6
[6] Segui W.T., Steel Design, Fourth. THOMSON, 2007.
[7] Timings R., Fabrication and Welding Engineering. New York: Newnes, 2008.
Downloads
Published
Issue
Section
License
The paper presented is assumed not to contain proprietary materials that are not protected by patents or patent applications. Responsibility for technical content and for protection from proprietary materials is the responsibility of the author and their organization and not the responsibility of the machine or its editorial staff. The primary author (first / appropriate) is responsible for ensuring that the article has been viewed and approved by all other authors. It is the responsibility of the author to obtain all copyright release permits required for the use of any copyrighted material in the manuscript before submission.
